gtres Опубликовано 9 марта, 2008 Поделиться Опубликовано 9 марта, 2008 I should ask you a suggestion or better an information.I have open an animation with ATL2 demo, I have load (cared) a file already served as ATL126 with all the done formulations.Filmed composed by 575 frames corresponding to 23 sec of tape with 25 fps compression h264Times of realization ATL126 63 hours (around 7 minutes to frame). Times of realization ATL2 demo 146 hours (around 85 minutes to frame) (but this because it is demo? )When I setting rendering I have not found the resolution that I had planned on 72 dpi in ATL126, while in ATL2 there is alone a "cursor" with writing "low-normal-tall" of defoult was on normal and I have left this way.But the management of the resolution there is in the commercial version or it is this way?If it is so to that resolution corresponds "low", "normal", "tall."?Thank you GTRES ItalyP.S. Sorry for my english... by Reverso.net Ссылка на комментарий Поделиться на другие сайты Поделиться
Админ-alexrvs Опубликовано 9 марта, 2008 Поделиться Опубликовано 9 марта, 2008 hi Reverso.net need test it Ссылка на комментарий Поделиться на другие сайты Поделиться
Рекомендуемые сообщения
Заархивировано
Эта тема находится в архиве и закрыта для дальнейших ответов.